Hot Dip Galvanized

These guy attachments provide an ecomonical and efficient means of fastening guys to poles. Well rounded wire grooves protect the bail of the strandvise or the cable from damage.

Fits 5/8" Bolts

45 Degree Ultimate Strength 10,000 lbs.

$5.00

Hot Dip Galvanized

Guy Attachments provide an economical and efficient means of fastening guys to poles. Well rounded wire grooves protect the strand from damage. The formed steel style guy attachments feature a closed strand loop. Wherever possible, installation should be made under the head of a machine bolt. Guy Attachments are not recommended to be mounted on the threaded end of a bolt as tensile and bending stresses on bolt threads can result in premature bolt failure less than the bolt minimum tensile strength.

Choose 5/8" or 3/4" Bolt Hole

Hot Dip Galvanized

Corner attachment clamps are used for angles of 35 degrees to 60 degrees.
Accommodates 5/8-inch diameter pole mounting bolt.
The inner pole mounting surface is curved with integral spurs for contact stability with the pole.
The integral thimble eyes will accept deadending devices up to 1/2-inch diameter.
Material: Ductile Iron
6" overall length, 2-1/2" between eyes.

$7.80

Suspension Clamps have bolts that are equipped with a shoulder that will prevent them from turning while the installer is tightening down the clamp. The Guy Clamps have parallel groves that will tighten down without damaging the cable.

The Suspension Clamps are used to secure cable to the poles and are offered in a straight clamp design as well as a curved angle design. The curve seen on the angle clamp prevent damage to the cable while turning small angles.

  Our Suspension Clamps are not manufactured by Hubbell or MaClean Power Systems.

The MS46N and MS60N are saddle-type suspension clamps.

Our suspension clamps are not manufactured by Hubbell or MaClean Power Systems.

Tensile Strenght for both sizes is 16,000lbs.

Choose: MS46N for 3/8" Cable or MS60N for 1/2" Cable

Wooden braces with aluminum ends.
A perfect way to keep the handrails of a Burma Bridge spread to the right size. Use pressure treated 4x4's with these brackets.
Picture shows a pair of Reversible Crossarm Braces attached to a utility pole supporting a 4x4 timber.
28" Long
Sold in Pairs

                                                               Hardware and 4x4 not included.

$25.00/pair

Galvanized Steel

An alternative to the wooden crossarm braces. These are also sold in pairs. Have rounded ends and are punched at one end with a 9/16" hole, with a 7/16" hole at the other end. Holes punched 1-inch from brace end to center of hole.

Length: 28"

$27.00/pair